5.0 KiB
Robot assembly
This file contains assembly instructions for building the robots and soldering the electronics.
Components
The robot consists of the following components:
- Adafruit Mini 3-Layer Round Robot Chassis Kit
- Wemos D1 mini
- Wemos D1 mini battery shield
- Wemos D1 mini motor shield (v1.0.0)
- LiPo battery
In addition you will need the following tools:
- A soldering iron
- Solder wire
- Heat shrink tube
- Some wires
- Battery connectors (female)
- Velcro tape
- Self adhesive tape
- Isolation tape
- Pin headers
For the camera based position detection of the robots you will need:
- A camera
- A printer
- Paper
- Cardboard
Assembly instructions
Robot chassis
Assemble the chassis according to the instructions provided by adafruit (see here).
Soldering the electronics
-
Solder on two rows of 8 male pin headers to the D1 mini
-
Solder on two rows of 8 female pin headers to the battery shield
-
Solder on two rows of 8 female pin headers to the motor shield as well as a single row of bent pins. Make sure they are soldered on the right way around.
-
In addition solder a jumper to the motor shield to connect the RTS and 3V pin. This will become important later on. Also solder the I2C bridge.
-
In the next step we connect the battery connector pins of the battery shield to the + and - pins of the motor shield. In addition we will add a connector to the motor shield where we can plug in the battery. Here is a schematic:
Note: I added a new connector instead of using the one already on the battery shield because the plug of my battery wouldn't fit in the on on the shield -
First, solder two wires to the + and - pins of the battery shield and isolate them with heat shrink:
| Description | Image |
|---|---|
| Cut two small pieces of wire (about 4 cm), remove the isolation on both ends and cover them with a bit of solder |  |
| Solder the first wire to the + pin of the battery shield |  |
| Solder the second wire to the - pin |  |
| Cover both wires with small pieces of heat shrink tube |  |
| Heat the shrink tube with a lighter |  |
| This is how the battery shield should look like with the two wires |  |
- Next, we create a connector for the female JST 2-Pin connector for plugin in the battery:
| Description | Image |
|---|---|
| Cut two small pieces of wire (about 3 cm), remove the isolation on both ends and cover them with a bit of solder |  |
| Solder the first wire to the JST connector |  |
| Solder the second wire to the JST connector |  |
| Cover both wires with heat shrink |  |
| Solder the wires to the motor shield, paying attention to the polarity (make sure it matches the polarity of your batteries!) |  |
- Now, stack the battery shield on top of the motor shield and solder the battery connector:
| Description | Image |
|---|---|
| This is how it should look like in the end. Make sure all of the exposed wires are covered in heat shrink |   |